Philips Magnavox ZV427MG9 - Manual (Page 35)

35 EN EN
Recording
Playback
Editing
Introduction
Connections
Basic Setup
Function Setup
VCR Functions
Others
Español
SATELLITE LINK
You can set the unit to start recording whenever it
detects the video signal from the external tuner.
Preparing for the satellite link timer recording:
Preparation on the tuner
• Satellite link accepts only the connection from L1 (rear)
with the external tuner. (The connection from L2 cannot
read any signals from the external tuner.)
• The external tuner should be equipped with some kind
of timer function. Using timer function of the tuner, set
it to output audio/video signals when it comes to the
time you want to start recording, and stop output audio/
video signals when it comes to the time you want to
finish recording. Refer to the tuner’s manual on how to
set the timer.
• Make sure to set the satellite link standby mode when
you finish setting.
1 Press [SETUP].
2 Use [
K / L] to select “Timer
Programming”, then press [OK].
3 Use [
K / L] to select “Satellite Link”,
then press [OK].
Timer Programming
Satellite Link
Timer Programming
4 Use [
K / L] to select the time, media
and recording mode, then press [OK].
Satellite Link
To Standby Mode
5:00PM DVD SP (2Hr)
Start Mode DVD
VCR
Use [
K / L] to set the desired starting
time, then press [ B ].
• The hour can be selected from 1 to 12 with AM
or PM.
• Repeat procedures in step 5 to set the desired
minutes.
• If you wish to go back to the left, press [ {].
6 Use [
K / L] to select a recording
media (“DVD” or “VCR”), then press
[
B ].
7 Use [
K / L] to select the recording
mode.
Refer to page 27 for details.