Garmin GPSMAP 296 - Manual (Page 11)

Turning On the GPSMAP 296
The first time you turn on your new GPSMAP 296, the receiver
must collect satellite data and establish its present location. To
ensure proper initialization, the GPSMAP 296 is shipped from the
factory in AutoLocate mode, which allows the receiver to “find
itself” anywhere in the world. Before you turn on the unit to start
initialization, be sure that the antenna is rotated up as shown on
page 1 , and it has a clear and unobstructed view of the sky to receive
satellite signals.
To turn on and off the GPSMAP 296:
1. Press and hold the POWER key. When the unit turns on, a
tone sounds and the Warning Page appears.
Warning Page
2. Read and be sure you understand the warning. Press
ENTER to continue.
3. To turn off the GPSMAP 296, press and hold the POWER
key again.
Adjusting the Backlight and Volume
The POWER key controls the 10 level backlight and volume of the
external speaker with 12/24-Volt Adapter Cable.
To adjust the backlight level or volume:
1. Press and quickly release the POWER key.
2. Press the ROCKER up to increase the brightness or down to
decrease. Press right to raise the volume or left to lower.
3. Press ENTER or QUIT to close the Backlight/Volume
adjustment window. Press MENU to view the options menu.
Backlight
adjustment slider
Volume
adjustment slider
Battery time remaining
and power source
indicator
GPSMAP 296 Pilot’s Guide 3
G
ETTING
S
TARTED
> T
URNING
O
N THE
GPSMAP 396