Grizzly G0704 - Manual (Page 16)

-14-
Model G0704 (Mfg. Since 08/11)
Inventory
contents Qty
A. mill/drill w/stand ......................................... 1
b. open end Combo Wrench 17/19 ................ 1
c. open end Combo Wrench 8/10 ................. 1
D. bottle for oil ............................................... 1
E. tool box...................................................... 1
f. large handwheel handle ........................... 1
G. small handwheel handles ......................... 3
H. t-bolts m10-1.5 x 60 (vise mounting) ......... 2
Flat Washers 10mm (vise mounting) .......... 2
hex nuts m10-1.5 (vise mounting).............. 2
I. drill Chuck .................................................. 1
J. Chuck Key .................................................. 1
K. phillips screwdriver .................................... 1
L. Flat screwdriver .......................................... 1
M. arbor b16 x r8 ........................................... 1
N. hex Wrench set 2, 3, 4, 5, & 6mm ...... 1 ea.
O. spindle pin ................................................. 1
Not Shown:
hex bolts m10-1.5 x 50 .............................. 4
Flat Washers 10mm ................................... 4
figure 4. g0704 out of the crate.
a
figure 5. inventory.
b
d
e
g h
i J
l K
m
C
F
n
o
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.