Clear cmos jumper – Global Upholstery Co. 2801330 User Manual

Page 70

Page 83

KINO-LX Motherboard

Figure 4-3: Jumper Locations

4.6.1 Clear CMOS Jumper

Jumper Label:

JP4

Jumper Type:

3-pin header

Jumper Settings:

Jumper Location:

If the PCB

fails to boot due to improper BI

OS settings, use this connector to clear the

CMOS data and reset the system BIOS inform

ation. To do this, use the jumper cap to

close pins 2 and 3 for a few seconds then reinstall the jumper clip back to pins 1 and 2.

If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault

may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the

following:

Enter the correct CMOS setting

Load Optimal Defaults

Load Failsafe Defaults.

After having done one of the above, save the changes and exit the CMOS Setup menu.