Global Upholstery Co. 2801330 - Manual (Page 67)

Page 80
IEI® Technology, Corp.
KINO-LX Motherboard
NOTE:
When two EIDE disk drives are connected together, back-end jumpers on
the drives must be used to configure one drive as a master and the other as
a slave.
4.5.2 COM3-COM6 RS-232 Serial Port Installation
The cable used to connect the motherboard to an RS-232 serial port is a 10-pin header to
male D-sub 9 connector. To connect an RS-232 serial port to the motherboard, follow the
instructions below.
Step 1:
Step 2:
Step 3:
Step 1:
Find the RS-232 cable in the kit that came with the motherboard.
Connect the 10-pin connector end of the cables to the COM3 to COM6 box
headers on the motherboard. Be sure to align the red wire on the connector to
pin 1 on the box header.
Connect the other end of the cables to standard female D-sub 9 connectors.
Step 0:
4.5.3 COM2 RS-232/485 Serial Port Installation
To connect an RS-232/485 serial port to the motherboard, follow the instructions below.
Connect the 14-pin connector end of an RS-422/485 serial port cable to the
CN10 connector on the motherboard. Step 0:
NOTE:
Be sure to configure the JP2 COM2 RS232/RS485 Select Jumper for either an
RS-232 or RS-485 connection. Refer to Section 4.5 for more information.