Global Upholstery Co. 2801330 - Manual (Page 62)

Page 75
KINO-LX Motherboard
o
Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the user’s body and help to prevent ESD damage.
Place the motherboard on an antistatic pad
o
When the motherboard is installed and configured, place it on an
antistatic pad. This helps to prevent potential ESD damage.
Turn off all power to the motherboard
o
When working with the motherboard, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the system.
Before an d during the installation of the motherboard
remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
use the product before all the cables and power connectors are properly
connected.
allow screws to come in contact with the PCB circuit, connector pins, or its
components.
4.3 Unpacking
NOTE:
If any of the items listed below are missing when the PCB is unpacked,
do not proceed with the installation and contact the reseller or vendor
motherboard was purchased from.
4.3.1 Unpacking Precautions
Users should ground themselves to remove any static charge before touching