Grizzly COMBINATION SANDER G1183 - Manual (Page 24)

-22-
model g1183/g1276 (mfg. since 3/10)
Dust Collection
Recommended CfM at:
3" dust port ................................220 CFm
2
1 ⁄
2
" dust hose ........................... 150 CFm
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
figure 24. dust hoses attached.
To connect the sander to the dust collection
system:
1. Fit the dust hoses over both dust ports, as
shown in figure 24, and secure them in
place with hose clamps.
2. tug the hoses to make sure they do not
come off. Note: A tight fit is necessary for
proper performance.
DO NOT operate the Model G1183/G1276
without an adequate dust collection system.
This sander creates substantial amounts of
wood dust while operating. failure to use a
dust collection system can result in short
and long-term respiratory illness.