Grizzly COMBINATION SANDER G1183 - Manual (Page 17)

model g1183/g1276 (mfg. since 3/10)
-15-
Inventory
The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, check
the mounting location on the machine or the
packaging materials. Sometimes parts are
pre-installed for shipping, or they become
hidden by packaging materials.
Shipping Inventory: (figure 8) Qty
A. sander assembly .......................................1
B. sanding Belt table .....................................1
C. Belt table trunnion ....................................1
D. dust port 3" ................................................1
E. disc table w/trunnions ..............................1
f. miter gauge assembly ...............................1
G. dust hose assembly 2 1 ⁄
2
" ..........................1
H. hardware (not shown):
— Quick-release tension lever .................1
— hex Bolts
5 ⁄
16
"-18 x 1" ..............................3
— Flat Washers 5 ⁄
16
" ....................................3
— Flange screws 1 ⁄
4
"-20 x 1 ⁄
2
" .....................2
— phillips head screws #10-24 x 3 ⁄
8
" .........2
— hex Wrench 6mm ...................................1
figure 8. shipping inventory.
a
B
e
d
F
C
g