Garmin HM210DP/DI - Manual (Page 93)

Configuring Firewall Settings
EN/LZT 108 6492 R2 - October 2003 85
Enable if you configure a Log Tag.
Start/End Time: The time range during which this rule is to be in
effect, specified in military units.
Src IP Address: IP address criteria for the source computer(s)
from which the packet originates. Use the
following expressions to specify IP:
any: any source IP address
lt: less than
lteq: less than or equal to
gt: greater than
eq: equal to
neq: not equal to
range: within the specified range, inclusive
out of range: outside the specified range
self: the IP address of the router interface on
which this rule takes effect.
Dest IP Address: IP address rule criteria for the destination
computer(s), i.e. the IP address of the computer
to which the packet is being sent.
In addition to the options described for the “Src
IP Address” field, the following option is
available:
bcast: Specifies that the rule will be invoked for
any packets sent to the broadcast address for the
receiving interface. (The broadcast address is
used to send packets to all hosts on the LAN or
subnet connected to the specified interface).
When you select this option, you do not need to
specify the address, so the address fields are
dimmed.
Protocol: The basic IP protocol criteria that must be met for
a rule to be invoked. Using the options in the
drop-down list, you can specify that packets must
contain the selected protocol (eq), that they must
not contain the specified protocol (neq), or that
the rule can be invoked regardless of the protocol
(any). TCP, UDP and ICMP are commonly IP
protocols; others can be identified by number
from 0-255 as defined by IANA.
Apply Stateful
Inspection: If this option is enabled, then stateful filtering is
performed and the rule is also applied in the
other direction on the given interface during an IP
session.