beautypg.com

3 choosing a place for the router – Garmin HM210DP/DI User Manual

Page 12

background image

Hardware Description and Installation

4

EN/LZT 108 6492 R2 - October 2003

2.2.2

Back Panel and Connectors

The following figure illustrates the back panel of your HM210dp/di:

Figure 2 - Back Panel of the HM210dp/di

Description of connectors and buttons:

DSL – The DSL port is used for connecting the HM210dp/di to the
ADSL service port (splitter/filter or phone outlet) using the supplied
ADSL line cable (RJ11 – RJ11).

LAN – The LAN port (Ethernet 10/100 BaseT) connect the
HM210dp/di to your PC’s Ethernet port, or to the uplink port on your
LAN’s hub, using the supplied Ethernet cable (RJ45 – RJ45).

RESET button (tiny hole) – Used to reset and restore the
HM210dp/di to default settings.
Push a paper clicp into the hole and hold for three seconds before
releasing. Then wait for the device to finish boot up.

Power button – Used to switch the HM210dp/di ON and OFF.

PWR – Power socket for connecting the HM210dp/di to a power
outlet by using the supplied power adapter.

2.3

Choosing a Place for the Router

The HM210dp/di should be placed on a flat surface. Be sure to choose a
location that enables you to see the LEDs, is close to a power outlet, ADSL
outlet, and the PC.

NOTE! Proper ventilation is necessary to prevent the product from
over-heating. Do not block or cover the slots and openings on the
device, which are intended for ventilation and proper operation.