Garmin HM210DP/DI - Manual (Page 31)

Basic Configuration
EN/LZT 108 6492 R2 - October 2003 23
5. Select Admin > Commit & Reboot and click the Commit button to
store your changes to permanent memory.
6. You may need to create a new WAN interface, or modify an existing
interface, so that it uses the new VC. See the instructions in the
following sections for configuring a PPP (section 5.2), EoA (section
5.3) or IpoA (section 5.4) interfaces, depending on the type you use
to communicate with your ISP.
5.1.2 Modifying ATM VCs
Your device may already be preconfigured with the necessary ATM VC
properties, or the table may contain placeholder values that you must
change before using the device. Contact your ISP to determine your ATM
VC values. Follow these instructions to modify a preconfigured VC:
1. From the ATM VC Configuration page, click in the “Actions”
column for the interface you want to modify. The ATM VC Interface
– Modify page displays.
2. Enter the new VPI and VCI values, select the Mux Type, or change
the maximum number of protocols that the VC can carry, as
directed by your ISP.
You cannot modify the interface type over which an existing VC
operates (aal5-0, for example). If you want to change the interface
type, you must delete the existing interface, create a new one, and
select the desired interface type.
3. After entering the fields above, click the Submit button and when
the confirmation page appears, click Close.
4. Select Admin > Commit & Reboot and click the Commit button to
store your changes to permanent memory.