GTO RB923 rev - Manual (Page 10)

7
IMPORTANT SAFETY INSTRUCTIONS
Warning Signs and Labels
These warning labels should be found at the locations specified below. If any of them are missing, immediately contact GTO
for replacements.
1. KEEP CLEAR! Gate may move at any time.
2. Do not allow children to operate gate or
play in gate area.
3. This gate is for vehicles only. Pedestrians
must use a separate entrance.
Moving Gate Can Cause
Injury Or Death
WARNING
!
warning signs (2 enclosed) to be installed on each side
of the gate (3–5 feet above the bottom of the gate)
RB2002
Maximum Gate: 1000 lb. (453.5 kg); 20 ft. (6.1 m)
Voltage: 12 Vdc; Frequency: 0 Hz; Power: 49.7 W
Class I, II and III Vehicular Swing Gate Operator.
Serial Number: 2000-xxxxxxx
9901178
Conforms to UL 325 STANDARDS
TO MANUALLY OPEN AND CLOSE THE GATE:
1. Turn control box power switch OFF.
2. Remove hairpin clip and clevis pin from front mount.
3. Pull front mount away from gate bracket.
Disconnect operator ONLY when the control box power
switch is OFF and the gate is NOT moving.
Series
GTO, Inc. Tallahassee, Florida USA
2000
product identification and manual operation label installed on
control box cover
1. KEEP CLEAR! Gate may move at any time.
2. Do not allow children to operate gate or play in gate area.
3. This gate is for vehicles only. Pedestrians must use
separate entrance.
WARNING
!
MOVING GATE
Can Cause Injury or Death
RB979
warning labels (2) installed on each side of
operator housing
L I S T E D
¤
US C