GIGABYTE 7VT600-RZ - Manual (Page 9)

- 9 - Hardware Installation Process
English
Hardware Installation Process
To set up your computer, you must complete the following steps:
Step 1- Set System Jum per (JP1)
Step 2- Install the Central Processing Unit (CPU)
Step 3- Install memory modules
Step 4- Install expansion cards
Step 5- Install I/O Peripherals cables
Step 1: Set System Jumper (JP1)
The system bus frequency can be switched at 100/133/166/200M Hz by adjusting system jumper (JP1).
(The internal frequency depend on CPU.)
The "JP1" must set to "Auto" when you are using
FSB 266/333/400MHz CPU.
100MHz : Fix FSB 200M Hz CPU
Auto : Support FSB 266/333/400 MHz CPU
Open: Auto
Close: 100MHz (Defualt)
1
1
JP1 CPU CLOCK
100MHz
Auto
1-2 Close Open
Step 1
Step 4
Step 5
Step 5
Step 2 Step 3
Step 5