GIGABYTE 7VT600-RZ - Manual (Page 27)

BIOS Setup - 27 -
English
" * " For 7VT600-RZ-C only.
F USB Keyboard Support
M When a USB keyboard is installed, please set at Enabled.
8 Enabled Enabled USB Keyboard Support.
8 Disabled Disabled USB Keyboard Support. (Default value)
F USB Mouse Support
8 Enabled Enabled USB M ouse Support.
8 Disabled Disabled USB Mouse Support. (Default value)
F VIA LAN Boot ROM *
This function decide whether to invoke the boot ROM of the onboard LAN chip.
8
Disabled Disable this function. (Default Value)
8 Enabled Enable this function.
F Onboard Serial Port 1
8 Auto BIOS will autom atically setup the port 1 address.
8 3F8/IRQ4 Enable onboard Serial port 1 and address is 3F8,Using IRQ4. (Default value)
8 2F8/IRQ3 Enable onboard Serial port 1 and address is 2F8,Using IRQ3.
8 3E8/IRQ4 Enable onboard Serial port 1 and address is 3E8,Using IRQ4.
8 2E8/IRQ3 Enable onboard Serial port 1 and address is 2E8,Using IRQ3.
8 Disabled Disable onboard Serial port 1.
F Onboard Serial Port 2
8 Auto BIOS will autom atically setup the port 2 address.
8 3F8/IRQ4 Enable onboard Serial port 2 and address is 3F8,Using IRQ4.
8 2F8/IRQ3 Enable onboard Serial port 2 and address is 2F8,Using IRQ3. (Default Value)
8 3E8/IRQ4 Enable onboard Serial port 2 and address is 3E8,Using IRQ4.
8 2E8/IRQ3 Enable onboard Serial port 2 and address is 2E8,Using IRQ3.
8 Disabled Disable onboard Serial port 2.
F OnBoard Parallel port
M This feature allows you to select from a given set of param eters if the parallel port uses the
onboard I/O controller.
8
378/IRQ7 Enable onboard LPT port and address is 378, Using IRQ7.(Default Value)
8 278/IRQ5 Enable onboard LPT port and address is 278,Using IRQ5.
8 3BC/IRQ7 Enable onboard LPT port and address is 3BC,Using IRQ7.
8 Disabled Disable onboard parallel port.
F UART Mode Select
This item allows you to determine which Infra Red(IR) function of Onboard I/O chip.
Normal Set onboard I/O chip UART to Normal Mode. (Default Value)
IrDA Set onboard I/O chip UART to IrDA M ode.
ASKIR Set onboard I/O chip UART to ASKIR Mode.
SCR Set onboard I/O chip as Smart Card interface.