GIGABYTE 7VT600-RZ - Manual (Page 33)

BIOS Setup - 33 -
English
F Spread Spectrum Modulated
8 Disabled Disable clock spread spectrum.
8 Enabled Enable clock spread spectrum.(Default value)
F CPU Host Clock Control
Note: If system hangs up before enter CMOS setup utility, wait for 20 sec for times out reboot . When
tim e out occur, system will reset and run at CPU default Host clock at next boot.
8
Disable Disable CPU Host Clock Control.(Default value)
8 Enable Enable CPU Host Clock Control.
F CPU Host Frequency (MHz) (By switch SW1)
8 100 Set CPU Host Clock to 100MHz~132M Hz.
8 133 Set CPU Host Clock to 133MHz~165M Hz.
8 166 Set CPU Host Clock to 166MHz~200M Hz.
8 200 Set CPU Host Clock to 200MHz~254M Hz.
FPCI/AGP Frequency (MHz)
8 The values depend on CPU Host Frequency(Mhz) .
F DRAM Clock (MHz)
8 Please set DRAM Clock according to your requirement. (Default value: Auto)
If you use DDR266 DRAM module, please set "DRAM Clock(MHz)" to "133-DDR266". If you use
DDR333 DRAM module, please set "DRAM Clock(MHz)" to "166-DDR333". If you use DDR400
DRAM module, please set "DRAM Clock(MHz)" to "200-DDR400".
Incorrect using it may cause your system broken. For power End-User use only!
F CPU OverVoltage Control
Increase CPU voltage m ay get stable for Over_Clock. But it may damage to CPU when enable this
feature.
8 Auto Supply voltage as CPU reguired. (Default value)
8 +5% / +7.5% / +10% Increase voltage range as user selected.
F AGP OverVoltage Control
Increase AGP voltage may get stable for Over_Clock. But it may damage to AGP Card when enable this
feature.
8 Auto Supply voltage as AGP Card reguired. (Default value)
8 +0.1V ~ +0.3V Set AGP voltage from 1.6V~1.8V.
F DIMM OverVoltage Control
Increase DRAM voltage may get stable for Over_Clock. But it may dam age to DRAM m odule when
enable this feature.
8 Auto Supply voltage as DRAM module reguired. (Default value)
8 +0.1V ~ +0.3V Set DIMM voltage from 2.6V~2.8V.