Gateway 6400 - Manual (Page 47)

38 Replacing and Adding System Components
4 Insert the new DIMM into the socket and align the two notches in the
DIMM with the two notches in the DIMM socket.
5 Gently press the DIMM into the socket until it is firmly seated. Inserting
the DIMM automatically locks the socket latches on each end of the
DIMM.
6 Close the case by following the instructions on page 20.
7 Reconnect peripherals, the modem cord, and the power cord, then turn
on the system.
To add or remove DIMMs:
1 Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2 Remove the left side cover panel. (See “Removing the side cover” on
page 18 and “Preventing static electricity discharge” on page 15.)
3 If you are removing a DIMM, pull open the socket latches on each side
of the DIMM socket, then lift the DIMM out of the socket. Store the
DIMM in an antistatic container.
05032.book Page 38 Monday, July 10, 2000 11:43 AM