Gateway 6400 - Manual (Page 41)

32 Replacing and Adding System Components
7 Set the drive jumpers to the appropriate settings (refer to your drive
documentation for jumper settings).
8 Align the rails with the bay, then slide the drive into the chassis until
the locking tabs snap into place.
9 Connect the power and data cables, making sure the cables match their
original position.
10 Close the case by following the instructions on page 20.
11 Reconnect peripherals, the modem cord, and the power cord, then turn
on the system.
12 Run the configuration software, if necessary.
05032.book Page 32 Monday, July 10, 2000 11:43 AM