beautypg.com

0 magnum ds8016 installation, 1 locating magnum ds8016 dual-speed hubs, 1 table-top or shelf mounting – GarrettCom DS8016 User Manual

Page 23: Magnum ds8016 installation, Locating magnum ds8016 dual-speed hubs, Table-top or shelf mounting

background image

Magnum DS8016 Dual-Speed Stackable Hubs Installation and User Guide (07/06)

15

www GarrettCom com

.

.

3.0

Magnum DS8016 Installation

Before installing the equipment, it is necessary to take the

following precautions:

1.)

If the equipment is mounted in an enclosed or multiple rack

assembly, the environmental temperature around the equipment must
be less than or equal to 50

0

C.

2.)

If the equipment is mounted in an enclosed or multiple rack

assembly, adequate air flow must be maintained for proper and safe
operation.

3.)

If the equipment is mounted in an enclosed or multiple rack

system placement of the equipment must not overload or load
unevenly the rack system.

4.)

If the equipment is mounted in an enclosed or multiple rack

assembly, verify the equipment’s power requirements to prevent
overloading of the building/s electrical circuits.

5.)

If the equipment is mounted in an enclosed or multiple rack

assembly verify that the equipment has a reliable and uncompromised
earthing path.

6.)

If the intra-building wiring (cabling) is involved with this

product(NEBS), then it is recommended to have shielded cable and
the shield is grounded at both ends.

7.)

This equipment is for installation only in a Restricted Access

Location (dedicated equipment room service closet and the like) in
accordance with the National Electrical code.

Installation: This chapter provides instructions for installing the Magnum DS8016 hubs.

3.1

Locating Magnum DS8016 Dual-Speed Hubs

The location of a Magnum DS8016 Dual-Speed Hub is dependent on the physical

layout of the network. Typically the hub is placed where combinations of 10Mb and 100Mb

network devices need to be connected to communicate with each other. The 19” rack width

size of the unit allows it to be conveniently placed in a wiring closet, an office or a lab area,

and it can also be either shelf- or rack-mounted. (See instructions in 3.1.2 below). Rack-

mounting brackets are included with each unit.

Locate an AC receptacle that is within six feet (2 meters) of the intended Magnum

DS8016 site. The rugged metal case of the Magnum DS8016 will normally protect it from

accidental damage in a lab or workplace setting. Maintain an open view of the front to

visually monitor the status LEDs. Keep an open area around the unit so that cooling can

occur from the small fan on the left side while the unit is in operation.

3.1.1

Table-Top or Shelf Mounting

The Magnum DS8016 Dual-Speed Hub can be easily mounted on a table-top or

any suitable horizontal surface, and has four rubber feet to provide stability without

scratching finished surfaces.