Gateway 9210 - Manual (Page 47)

42 www.gateway.com
To install or replace memory:
1
Follow the instructions in “Preventing static electricity discharge” on page 29 .
2
Follow the instructions in “Opening the server case” on page 30 .
3
Pull the plastic tabs away from the sides of the memory module slot. If you are
replacing a memory module, lift the old module out of the slot.
4
Align the notch on the new module with the notch in the memory module slot and
press the module firmly into the slot. The tabs on the sides of the memory slot should
secure the memory module automatically.
5
Follow the instructions in “Closing the server case” on page 31 .
6
Turn on the server, then make sure that the operating system completely loads. If you
receive an error, see
“Memory” on page 74 .