Go-Video VR2945 - Manual (Page 29)

Follow the same procedure as Video Settings to select Audio Settings.
Digital Output
1
Use […/†] to select ‘Digital Output‘ while the Audio
submenu is displayed.
2
Press [ENTER] or [√] to go to the second level.
3
Use […/†] to select the desired digital output type.
4
Press [ENTER] to confirm your selection.
5
Press [SETUP] to exit the menu.
Off
No signal will be output from the Digital Audio Out jacks.
LPCM
Select when connected to a 2 channel digital stereo amplifier. The DVD Recorder+VCR's digital audio signal will
be output in the PCM 2ch format when you play a DVD (or VHS tape) recorded with a Dolby Digital (only for
DVD) or MPEG soundtrack. If the DVD is recorded with a DTS sound track then no sound will be heard.
Bitstream
Select when connected to a Dolby Digital or DTS decoder (or an amplifier or other equipment with a Dolby
Digital or DTS decoder).
Dynamic Range
While watching DVD movies, you may wish to compress the
dynamic range of the audio output (the difference between the
loudest and quietest passages). This allows you to listen to a
movie at a lower volume without losing clarity of sound. Set
‘Dynamic Range‘ to Low or High for this effect.
Follow the same procedure as ‘Digital Output‘ to set the Dynamic
Range.
28
Initial Setup
Audio
Digital Output Off
Dynamic Range Off
Virtual Surround Off
VCR Reception Stereo
Tape Play Back Hi-Fi
Instructions
Enter-Confirm Setup-Exit Move …†
Select Digital
Output
Off
Bitstream
LPCM
Audio
Digital Output Off
Dynamic Range Off
Virtual Surround Off
VCR Reception Stereo
Tape Play Back Hi-Fi
Instructions
Enter-Confirm Setup-Exit Move …†
Select Dynamic
Range
Off
Low
High
PREFERENCE / Audio Settings
Preference
Video
Audio
Parental Controls
Auto Play
Auto Clock
VCR
Instructions
Enter-Confirm Setup-Exit
Move …†