beautypg.com

Starting the autoloader, To start the autoloader – Gateway 820 LTO User Manual

Page 15

background image

11

Starting the autoloader

www.gateway.com

Starting the autoloader

To start the autoloader:

1

Attach the power cord to the autoloader, then attach the other end to an
AC outlet. For more information about the power cord, see “Power
specifications” on page 57.

2

Connect the SCSI cable and the terminator. For more information about
the SCSI interface, see “SCSI interface” on page 52.

a

Connect one end of the SCSI cable to one of the SCSI connectors on
the back of the autoloader.

b

Connect the other end of the SCSI cable to the SCSI connector on
the SCSI host bus adapter or to the previous device on the SCSI bus.

c

If this is the last device in the SCSI chain, connect the SCSI terminator
to the remaining SCSI connector on the back of the autoloader.

To change the SCSI ID settings, see “Changing the SCSI ID settings” on
page 53.

SCSI ID Default Settings

Autoloader

5

Tape drive

6

SCSI connectors

Power connector