Grizzly G4000 - Manual (Page 25)

-24- G4000 9'' x 19'' Lathe
S SE EC CT TIIO ON N 7 7:: M MA AIIN NT TE EN NA AN NC CE E
L Lu ub brriic ca attiio on n
G Ge ea arrb bo ox x -- Lubrication for the Gearbox is provid-
ed through 4 oil caps. Add a squirt or two of oil
after every three-to-four hours of use.
F Fiig gu urre e 3 38 8..
Your Model G4000 will function best when it is
clean and well lubricated. Take the time to wipe
down and oil the machine after use. We recom-
mend using ISO 68 or SAE 20W non-detergent
oil unless otherwise specified.
A Ap prro on n - Apply lubrication to the apron through
the ball fitting on the front face of the apron.
F Fiig gu urre e 3 36 6..
E Ex xtte errn na all G Ge ea arriin ng g -- One-to-two squirts of oil into
the oil ball on the gear hubs. F Fiig gu urre e 3 37 7..
Apply only a minimal amount of oil to the teeth of
the end gears. Avoid getting oil on the belt or pul-
leys when lubricating.
F Fiig gu urre e 3 36 6.. Apron lubrication point.
F Fiig gu urre e 3 37 7.. Oil ball on gear hubs.
F Fiig gu urre e 3 38 8.. Gearbox lubrication caps.
A AL LW WA AY YS S d diis sc co on nn ne ec ctt tth he e e elle ec cttrriic c p po ow we err tto o
tth he e m ma ac ch hiin ne e b be effo orre e s se errv viic ciin ng g.. N NE EV VE ER R llu ub brrii--
c ca atte e y yo ou urr lla atth he e w wh hiille e iitt iis s rru un nn niin ng g..
Please note that the large toothed pulley that is to
the left of the gears shown in
F Fiig gu urre e 3 37 7 has an oil
ball on the end of the shaft it is mounted to. Make
sure to apply one-to-two squirts into the oil ball.