Grizzly G4000 - Manual (Page 12)

G4000 9'' x 19'' Lathe -11-
The follow rest is normally used with small diam-
eter stock to prevent the workpiece from ''spring-
ing'' under pressure from the turning tool. To
install the follow rest:
1 1.. The follow rest is secured to the saddle with
two cap screws.
S Se ee e F Fiig gu urre e 6 6..
2 2.. The sliding fingers on the follow rest are
similar to those on the steady rest, and
should be lubricated to prevent premature
wear.
F Fiig gu urre e 6 6.. Follow rest secured to saddle.
F Fiig gu urre e 5 5.. Steady rest in place.
S Stte ea ad dy y R Re es stt
The steady rest supports long, small diameter
stock that otherwise could not be turned. The
steady rest can also replace the tailstock to allow
for cutting tool access at the outboard end of your
workpiece.
To mount the steady rest :
1 1.. Secure to bedway from below with the lock-
ing plate.
2 2.. A single M8-1.25 x 55mm cap screw, along
with a nut and washer, holds the steady
rest in place.
S Se ee e F Fiig gu urre e 5 5..
3 3.. The sliding fingers on the center steady rest
should receive periodic lubrication while in
use to prevent premature wear.
F Fo ollllo ow w R Re es stt
Sliding Fingers
Cap Screw
Cap Screws