Grizzly G0604 - Manual (Page 18)

-16-
G0604 6" X 56" Jointer
When correctly set, the knife will barely touch
the straightedge, as shown in
Figure 11.
—If your outfeed table is correctly set, no
adjustments are necessary.
—If the knife lifts the straightedge off the
table or it is below the straightedge, then
the outfeed table must be reset. Refer to
Setting Outfeed Table Height on Page
38.
Extension Table
Components and Hardware Needed: Qty
Extension Table ................................................. 1
Cap Screws M6-1 x 20 ...................................... 2
To install the extension table:
1. Attach the extension table to the infeed table
with the cap screws, as shown in Figure 12,
but do not fully tighten the cap screws yet.
Figure 12. Installing extension table.
2. Use the straightedge to adjust the extension
table flush with the infeed table.
3. Tighten the cap screws.
Figure 11. Using a straightedge to align outfeed
table height with knife at TDC.
������������
������� ������