Grizzly G0440 - Manual (Page 39)

Model g0443 (Mfg. since 11/09)
-37-
Removing/Replacing
filter
the filter for canister filter assemblies manufac-
tured since november, 2009, can be removed
from the assembly so that it can be replaced or
rinsed off (see the instructions in the next subsec-
tion).
removing/installing the filter requires removing
the canister filter assembly from the dust collec-
tor and disassembling it. Follow the instructions
below to perform this procedure.
refer to the parts breakdown diagrams and list-
ings beginning on
Page 45 to order the correct
filter from grizzly at 800-523-4777.
Tools Needed Qty
open-end wrench 10mm .................................. 1
wrench or socket 12mm ................................... 2
To replace the canister filter:
1. disConneCt MaChine FroM power!
2. remove the bag clamp and collection bag
from the canister assembly.
3. pull the black handle all the way down and
secure the cable into the handle hook at the
bottom of the canister assembly, as shown in
figure 59, to hold it in place during the fol-
lowing steps.
4. remove the canister assembly from the
dust collector and place it right-side up on a
stable, flat surface.
5. remove the six hex bolts, hex nuts, and flat
washers from the rim of the canister base, as
shown in
figure 60.
figure 59. Black handle cable secured in the
handle hook.
Black
handle
hook
figure 60. removing the hex nuts and flat
washers from the rim of the canister base.
Canister
Base
6. with help from another person to steady the
canister assembly, turn it upside down and
remove the two hex bolts, hex nuts, and flat
washers from the cross support (see
figure
61), then remove the canister base from the
assembly.
figure 61. Cross support fasteners.
remove these