Grizzly G0440 - Manual (Page 18)

-16-
Model g0443 (Mfg. since 11/09)
3. tighten the 1 ⁄
2
" lag bolts into the mounting
locations so they do not project more than
1 ⁄
2
" from the mounting board to the top of the
head, but leave them out enough to slide the
housing over. this will prepare the mounting
board for the mounting instructions described
in
assembly on Page 17.
Note: Predrill the mounting holes now, and
insert the lag screws when you mount the
motor/blower housing in the next section.
Materials Needed for Concrete/
Masonry Wall
• Concrete anchor studs 1 ⁄
2
" x 2 3 ⁄
4
" .............. 6
• hex nuts 1 ⁄
2
" ............................................... 6
• Flat washers 1 ⁄
2
" ......................................... 6
• hammer drill .............................................. 1
• Masonry drill Bit 1 ⁄
2
" ................................... 1
• level 4' ....................................................... 1
• pencil .......................................................... 1
• Measuring tape .......................................... 1
To mount the motor/impeller housing to a con-
crete or masonry wall:
1. Copy the mounting hole layout pattern from
the motor housing to your wall, making sure
the
Top Row Mounting Hole Height (see
figure 9 on Page 17) is correct for your dust
collector.
2. Mount the anchor studs to the wall in the
mounting hole locations for the motor/impel-
ler housing. this will prepare the mounting
board for the mounting instructions described
in
assembly on Page 17.
figure 10. Board fastened to wall and ready for
motor/blower housing assembly.
top row Mounting hole height
wall stud Centers