Grizzly G0440 - Manual (Page 19)

Model g0443 (Mfg. since 11/09)
-17-
assembly
To assemble the dust collector:
1. attach the wall mounting bracket to the motor/
blower housing with the provided (6) 3 ⁄
8
"-16 x
1" hex bolts, (12) 3 ⁄
8
" flat washers, and (6)
3 ⁄
8
"-16 hex nuts. refer to the parts breakdown
diagram on Page 44 for a graphical orienta-
tion of the parts.
2. with the help of assistants or power lift-
ing equipment, lift the motor/blower housing
assembly onto the hardware you mounted in
the
Wall Mounting section.
3. attach the 3 x 6mm foam tape to the top of
the intake cylinder, as shown in figure 11.
figure 11. Foam tape stuck on intake cylinder.
intake
Cylinder
Foam tape
4. attach the intake cylinder to the bottom of the
housing, as shown in figure 12, using (4)
5 ⁄
16
"-18 x 3 ⁄
4
" hex bolts and (4) 5 ⁄
16
" flat wash-
ers.
Note: Because this part of the dust collector
will not be accessible after assembly, con-
sider using medium strength thread locking
compound on the bolts that secure the intake
cylinder to the motor/blower housing assem-
bly. This added measure will ensure that the
fasteners will not come loose from vibration.
5. temporarily attach the intake barrel to the
housing with a barrel gasket in between, as
shown in
figure 13, using (4) 5 ⁄
16
"-18 x 3 ⁄
4
"
hex bolts and (4) 5 ⁄
16
" flat washers—and only
snug the bolts, rather than fully tighten them.
figure 13. example of securing blower on intake
barrel.
gasket here
intake Barrel
figure 12. attaching intake cylinder to the
bottom of motor housing.
intake
Cylinder
Blower
housing
The Model G0443 Cyclone
dust collector is a heavy
machine. Serious personal
injury may occur if safe
moving methods are not
used. To be safe, get assis-
tance or use power equip-
ment during the machine
assembly process.