Installation instructions, Installation, Installation - radiant fires – Stovax 8455 User Manual
Page 12: Control upgrade, Safety precautions, Unpacking
4. INSTALLATION - RADIANT FIRES
4.1 Fix the rear leg strap. See Diagram 1.
1
AR0019
4.2 Position the fire with the rear leg fully engaged under the rear
leg strap. Fasten the front legs using the fixings supplied.
4.3 “HAVE YOU PURGED THE GAS SUPPLY PIPES”. This is
essential to expel any foreign matter that might get blown into
the valve assembly causing blockages.
4.4 Connect the 8mm gas supply pipe to the fire. See Diagram 2 &
3.
2
AR0944
4.5 If the isolation tap is to be fitted under the fire, the GAZCO
GC0060 provides a neat and easy solution. See Diagram 3A.
3
3A
12
IMPORTANT: ENSURE THAT THE APPLIANCE IS
CORRECTLY ADJUSTED FOR THE GAS TYPE AND
CATEGORY APPLICABLE IN THE COUNTRY OF USE. REFER
TO DATABADGE AND TECHNICAL SPECIFICATIONS AT
THE FRONT OF THE BOOKLET. FOR DETAILS OF
CHANGING BETWEEN GAS TYPES, SECTION 9, SERVICING.
1. CONTROL UPGRADE
1.1 Your fire is fitted with a control valve that can be easily
upgraded to battery powered remote control. This upgrade
can be fitted by anyone capable of simple DIY jobs and
requires no special training. This upgrade can be obtained
through your local Gazco stockist.
1.2 STANDARD REMOTE CONTROL This remote control can
control the fire after the pilot has been lit. It can turn the main
burner on and regulate it from low through to high and back
again. It can turn the main burner off leaving the pilot burning.
GAZCO PART NUMBER 8455.
1.3 IMPORTANT - there is a thermostatic version of the upgrade
but this is NOT SUITABLE for open flame fires.
2. SAFETY PRECAUTIONS
2.1 This appliance must be installed in accordance with the rules
in force, and used only in a sufficiently ventilated space.
Please read all instructions before installation and use of this
appliance.
2.2 These instructions must be left intact with the user.
2.3 Do not attempt to burn rubbish on this appliance.
2.4 In your own interest, and those of safety, this appliance must
be installed by a competent person in accordance with local
and national codes of practice. Failure to install the appliance
correctly could lead to prosecution.
2.5 Keep all plastic bags away from young children.
3. UNPACKING
3.1 Remove the appliance from its packaging, and check that it is
complete and undamaged.
3.2 Put the loose ceramic parts to one side so that they are not
damaged during installation.
INSTALLATION INSTRUCTIONS
INSTALLATION