Genie TMZ-34 - Manual (Page 25)

Part No. 97866 Genie TMZ-34/19 23
Operator's Manual Fourth Edition • First Printing
Test the Tilt Sensor
12 Raise the jib boom approximately 6 in / 15 cm.
Raise the primary boom approximately 6 in /
15 cm off the boom rest. Raise the secondary
boom approximately 6 in / 15 cm off the boom
rest.
13 Locate the tilt sensor on
the chassis near the
ground controls.
14 Press down one side of the
tilt sensor and place the tilt
sensor test tool under one
of the posts.
Result: The alarm, located in the platform,
should sound after 1 second.
15 Test all ground and platform control functions.
Result: The primary boom up, the secondary
boom up and the jib boom up functions should
not operate. The primary boom down, the
secondary boom down, the jib boom down and
the turntable rotate functions should operate
normally.
16 Remove the tilt sensor test tool.
17 Turn the key switch to platform control.
FUNCTION TESTS
At the Platform Controls
18 Pull out the platform red Emergency Stop button
to the on position.
Test Emergency Stop
19 Push in the platform red Emergency Stop button
to the off position.
Result: All ground and platform control functions
should not operate.
Test the Horn
20 Pull out the red Emergency Stop button to
the on position.
21 Push the horn button.
Result: The horn should sound.
Test Boom Functions and Function Enable
22 Do not push a function enable button. Attempt to
activate each boom function button.
Result: All boom functions should not operate.
23 Push and hold the blue function enable button.
Activate each boom function button.
Result: Primary boom up, secondary boom up,
jib boom up and turntable rotate right should all
function.
24 Push and hold the yellow function enable button.
Activate each boom function button.
Result: Primary boom down, secondary boom
down, jib boom down and turntable rotate left
should all function.