Genie TMZ-34 - Manual (Page 21)

Part No. 97866 Genie TMZ-34/19 19
Operator's Manual Fourth Edition • First Printing
Set up
1 Position the machine directly below the desired
work area.
2 Set the parking brake.
3 Disconnect the trailer lights, chains and surge
brake safety cable from the vehicle.
4 Open the latch on the ball coupler.
5 Pull the jack release handle and rotate the
tongue jack to the lifting position.
6 Raise the tongue by turning the jack handle.
7 Open all boom hold-down latches.
8 Release the jib hold-down straps (if equipped).
Function Tests
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation
inspection.
3 Always perform function tests prior to
use.
Know and understand the function tests
before going on to the next section.
4 Inspect the workplace.
5 Only use the machine as it was intended.
Fundamentals
The function tests are designed to discover any
malfunctions before the machine is put into service.
The operator must follow the step-by-step
instructions to test all machine functions.
A malfunctioning machine must never be used. If
malfunctions are discovered, the machine must be
tagged and removed from service. Repairs to the
machine may only be made by a qualified service
technician, according to the manufacturer's
specifications.
After repairs are completed, the operator must
perform a pre-operation inspection and function
tests again before putting the machine into service.