Grizzly Vertical Milling Machines G0728 - Manual (Page 26)

-24-
Models G0728–31 (Mfg. Since 11/11)
Head Tilting
the head tilts 90° to the left or right (see
figure 25).
figure 25. head tilted 45° to the left.
Tools Needed Qty
Wrench 17mm.................................................... 1
To tilt the head left or right:
1. DisConnECt thE Mill FroM poWEr!
2. loosen the four hex nuts and lock washers
on both sides of the turret (see figure 26).
figure 26. head tilting hex nuts and lock
washers (2 of 4 shown).
head tilting
scale
4. rotate the speed dial to the minimum speed
(all the way to the left), and use the direction
lever to select the direction of table travel.
5. Flip the on/oFF switch up to turn the power
feed ON.
6. adjust the speed dial to move the table at the
correct speed for your operation.
Note: Power feed rates are difficult to pre-
cisely adjust. We recommend that you exper-
iment with different dial settings to find the
feed rate that best works for your operation.
7. When you are through using the power feed,
leave the direction lever in the center or
neutral position, and flip the on/oFF switch
down to turn the power feed
OFF.
Always keep the table locked in place
unless controlled movement is required
for your operation. unexpected table move-
ment during operations could cause the
cutter to bind with the workpiece, resulting
in personal injury, and possible damage to
the cutter and workpiece.
hex nuts and
lock Washers
(2 of 4)