FARGO electronic Quatro ID Card Printer User Manual
Page 12
8 Ribbons and Cards
3.
Open the Top Cover of the printer by gently grasping the
front sides of the cover and lifting upward. The cover will
tilt open from front-to-back.
4.
Open the Printhead Assembly by gently pulling up on the
assemblyÕs Release Tab and lifting upward. Allow the
assembly to swing completely open.
5.
Place the supply end of the ribbon in between the two
black Ribbon Drive Hubs located on the right-hand side of
the printerÕs interior. Make certain that the ribbon is fed
from underneath the ribbon roll. HINT: The Ribbon Drive
Hub nearest you, as you are looking into the printer from
the front, is spring loaded. Use the end of the ribbon
supply core to push in this Ribbon Drive Hub when
inserting the ribbon.
Release Tab
Printhead
Assembly
Quatro/510323 v3 1/8/99 10:48 AM Page 8