FUJITSU MAS3367 - Manual (Page 249)

5.2 INIT Error Recovery Methods (Recommended)
C141-E167 5 - 15
Table 5.3 Sense data error classification (2 of 4)
K* C* Q* Outline of Error L*
Recovery Method
(See Table 4.4.)
3 11 xx Unrecovered read error Need 12
13 00 Sync byte not found for data field
14 01 No record found
These errors were detected during accessing of the
disk media, but they were errors which could not
be recovered from through the IDD's retry
processing.
Positioning error Need 12 3 15 xx
This is an error of the disk drive’s seek system
3 19 xx SA information error Need 7
1C xx SA information error not found
The information recorded in (SA) on the disk
media cannot be read correctly.
31 00 Medium form at corrupted Need 18
FORMAT command failed
3
31 01
The data format on the disk media is not correct.
4 03 xx Peripheral device write fault Need 7
32 01 Defect list update failure
These are errors detected in the operation of the
disk drive.
4 15 xx Positioning error Need 12
This is an error of the disk drive's seek system.
4 32 00 No defect spare location available None 19
No usable alternate blocks exist on the disk drive.
4 40 nn Diagnostic failure on component 'nn' Need 13
An error was detected in the IDD's self-diagnosis.
4 44 nn Internal target failure Need 20
An internal hardware error or a microcode
detection error was detected in the IDD.
4 4C xx Calibration failed Need 10
C4 xx Drive failure
The initial seek was terminated abnormally. Or, a
serious error was detected in the drive's control
system.
* K: Sense Key C: Sense Code
Q: Sub-sense code L: Logging Necessary? (shown in Section 5.2.3)