FUJITSU MAS3367 - Manual (Page 244)

Sense Data Error Recovery Methods
5 - 10 C141-E167
Table 5.2 Sense and subsense codes (5 of 5)
C* Q* Name Explanation Sense
key
45 00 Select/Reselect failure A response wait time-out from the INIT was detected in the
RESELECTION phase. B
47 00 SCSI parity error A parity error was detected on the SCSI data bus. B
48 00 INITIATOR DETECTED
ERROR message received The INITIATOR DETECTED ERROR message was received from
the INIT. B
49 00 Invalid message error An unsupported or inappropriate message was received. B
4C nn Logical unit failed self-
configuration The IDD's initial setup failed. ('nn' is a Fujitsu unique code)
• A1: SA Read error (any 3/11/** error during SA read)
• A3: SA Read error (any 3/13/** error during SA read)
• A4: SA Read error (any 3/14/** error during SA read)
• A5: SA Read error (any 3/15/** error during SA read)
• A7: SA Read error (any 4/44/** error during SA read)
• A8: Invalid SA (Header/Check Sum)
• E0: Initial calibration failed
4
4D nn Tagged overlapped
command Before completing one command execution, new command having
the same tag number was issued to the same logical unit. (nn=queue
tag number) B
4E 00 Overlapped commands
attempted 1) Before execution of an untagged command was completed, the
same INIT issued a new command to the same LUN.
2) Before execution of a tagged command was completed, the same
INIT issued a command to the same LUN with the same tag. Or,
an untagged command was issued when not in the sense hold
state.
B
55 04 Insufficient Registration
Resource PERSISTENT RESERVATION OUT command is issued from
insufficient device server resource.
5
01 Spindle synchronized The rotational synchronization operation was completed. 6 5C
02 Spindle not synchronized. Rotational synchronization deviated. 6
5D nn SMART predictive failure SMART related sense data
• 12: The read error rate attribute has reached the failure threshold.
• 14: The frequency of grown defect allocation attribute has
reached the failure threshold.
• 43: The seek error rate attribute has reached the failure threshold.
• 56: The spin up time attribute has reached the failure threshold.
• 64: The remaining alternate sector count attribute has reached the
failure threshold.
• FF: The drive is in test mode.
0, 1, 6
90 00 Initiator's SCSI ID not
identified Since the SCSI ID of the INIT was not notified in the SELECTION
phase, the RESERVE, RESERVE EXTENDED, RELEASE AND
RELEASE EXTENDED commands cannot be executed. 5
C4 nn Drive Failure A serious error was detected in the drive's control system. ('nn' is a
Fujitsu unique code)
• 00: Abnormal Rotation of Spindle Motor
• 01: Any error at Spindle Motor Start
• 30: On track failure
4
* C: Sense Code, Q: Sub-sense Code