FUJITSU MAS3367 User Manual
Page 241
5.1 Sense Data
C141-E167
5 - 7
Table 5.2
Sense and subsense codes (2 of 5)
C*
Q*
Name
Explanation
Sense
key
13
00
Sync Byte not found for
Data field
SB (Sync Byte) could not be detected in the Data area.
1, 3, B
14
00
Record entity not found
Expected data from a sector was undetected. (LBA compare error
detected by FMT)
1, 3, B
01
Record not found
The target data block (sector) could not be detected.
3, B
01
Mechanical positioning
Error
A seek error occurred in the drive.
1, 3, B
15
02
Positioning Error detected
by read of medium
LBA did not match due to Cylinder number’s mismatch.
1, 3, B
01
Recovered data with retries A data error was recovered from by reading was retried.
1
02
Recovered data with
positive head offset
A data error was recovered by read retry with offsetting head to
positive direction.
1
03
Recovered data with
negative head offset
A data error was recovered by read retry with offsetting head to
negative direction.
1
06
Recovered data without
ECC: data auto-
reallocated
Automatic alternate allocation was applied without ECC correcting a
data error.
1
17
08
Recovered data without
ECC: recommended
rewrite
Rewriting to the same sector was performed without ECC correcting
a data error.
1
02
Defect list error in primary
list
An error was detected during reading of the defect list (P List).
3
03
Defect list error in grown list An error was detected during reading of the defect list (G List).
3
80
Log information read error
An error was detected during reading of statistical information.
3
81
Log information write
error
A write error was detected during writing of statistical information.
3
82
Drive Parameter SA read
Error
An error was detected during reading of SA information (Device
Information)
3
83
Drive Parameter SA write
Error
An error was detected during writing of SA information (Device
Information)
3
19
84
Mode Select SA write
Error
An error was detected during writing of SA information (Mode
Select Paramenter)
3
1A
00
Parameter list length error There is a mistake in the indication of the parameter list page length.
5
01
Primary defect list not found The defect list (P List) header is incorrect.
3
02
Grown defect list not found
The defect list (G List) header is incorrect.
3
1C
90
SA information list not
found
The SA information (MODE SELECT parameter) header is
incorrect.
3
00
Miscompare during verify
operation
Comparison of data transferred from the INIT by a VERIFY
command (when the Byte Check mode was specified) with data read
from the disk media was terminated unsuccessfully.
E
E
1D
80
Miscompare during self-
configuration
There is an unmatch to compare read data with write data during
self-configuration.
* C: Sense Code, Q: Sub-sense Code