FUJITSU MB2198-130 - Manual (Page 17)

10
➀ Emulator connector
This connector accepts the emulator (Mounted on the rear side).
➁ IC socket for evaluation MCU
401-pin PGA IC socket for mounting an evaluation MCU
➂ Memory size select switch
This switch sets the capacity of the memory board to use external-memory emulation.
➃ DVCC bypass capacitor sockets
These sockets accept bypass capacitors to be inserted between DVCC and GND pins.
➄ Reset signal setting jumper plugs
These jumper plugs are used to set the reset signal supply origin.
➅ Memory board connector
This connector accepts a memory board (for external-memory emulation).
➆ Flat cable connectors
Use the bundled flat cables to connect the header to the adapter board (Mounted on the rear side).
➇ Memory connective switches
These switches disconnect buffers so that signal conductors can be used without being loaded when
external-memory emulation is not used or when address lines disabled by memory capacity switch-
ing are used as user resources.
➈ Jumper plugs for setting the evaluation MCU power supply
These jumper plugs are used to make settings for the evaluation MCU.
➉ Clock input IC sockets and clock input select jumper plugs
The IC sockets accept an oscillator and a capacitor for the main clock and subclock; the jumper plugs
are used to set the clock supply source.
Chapter 2 Product Description