FujiFilm A470 - Manual (Page 7)

12 13
Getting
Ready
1
12
LOADING THE BATTERY AND THE xD-Picture Card
4 Close the battery cover.
◆
How to replace the xD-Picture Card
◆
Push the xD-Picture Card into the slot and then
slowly remove your finger. The lock is released and
the xD-Picture Card is pushed out.
Checking the battery charge
1 There is ample battery charge.
2 The battery is almost half charged.
3 There is insufficient charge left in the battery.
The battery will soon run out. Have a new
battery ready.
4 The battery is depleted. The display will shortly
go blank and the camera will stop working.
Replace or recharge the battery. Blinking red
Lit white
Lit white 1
2
4
Lit red 3
Turn the camera on and check the battery level indicator on the LCD monitor.
● ! Battery with no remaining charge ( V blinking red) may
cause camera faults such as the camera turning itself off
without retracting the lens. Always load a new or fully
charged battery.
“Z”, “E” or “Ô appears as a small icon on
the left-hand side of the LCD monitor.
● ! Depending on the camera mode, the transition from “ Ã ” to
“ V ” may occur more quickly.
● ! Due to the nature of the battery, the battery level indicator
(
E , Ã or V ) may appear early when the camera is
used in cold locations. This is normal. Try warming the
battery in your pocket or a similar location before use.
“V” appears as a large icon in the center of the
LCD monitor.
N 10
N 10
◆
LCD power save function
◆
When the LCD power save function is active, the LCD monitor darkens to reduce power consumption if
the camera is not used for 10 seconds (
➡P.79).
Pressing the shutter button down halfway (or pressing any other button) recovers the LCD monitor
brightness.