FieldServer FS-8704-14 - Manual (Page 30)

FS-8704-14 EtherNet/IP Manual Page 30 of 31
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: [email protected]
Appendix D.3. Error Codes
General
Status Extended
Status
Description
0x01 0x0100 Connection in Use or Duplicate Forward Open.
0x01 0x0103 Transport Class and Trigger combination not supported
0x01 0x0106 Ownership conflict
0x01 0x0107 Connection not found at target application.
0x01 0x0108
Invalid Connection Type. Indicates a problem with either the Connection Type or
Priority of the Connection.
0x01 0x0109 Invalid connection size
0x01 0110 Device not configured
0x01 0x0111
RPI not supported. May also indicate problem with connection time-out multiplier
or production inhibit time.
0x01 0x0113 Connection Manager cannot support any more connections
0x01 0x0114
Either the Vendor Id or the Product Code in the key segment did not match the
device
0x01 0x0115 Product Type in the key segment did not match the device
0x01 0x0116 Major or Minor Revision information in the key segment did not match the device
0x01 0x0117 Invalid Connection Point
0x01 0x0118 Invalid Configuration Format
0x01 0x0119 Connection request fails since there is no controlling connection currently open.
0x01 0x011A Target Application cannot support any more connections
0x01 0x011B RPI is smaller than the Production Inhibit Time
0x01 0x0203 Connection cannot be closed since the connection has timed out
0x01 0x0204 Unconnected Send timed out waiting for a response.
0x01 0x0205 Parameter Error in Unconnected Send Service
0x01 0x0206 Message too large for Unconnected message service
0x01 0x0207 Unconnected acknowledge without reply
0x01 0x0301 No buffer memory available
0x01 0x0302 Network Bandwidth not available for data
0x01 0x0303 No Tag filters available
0x01 0x0304 Not Configured to send real-time data
0x01 0x0311
Specified Port Not Available – the FieldServer is trying to open a connection but
the target port is not available at the remote device. This can be resolved by using
the correct EIP_Path parameter.
0x01 0x0312 Link Address specified in Port Segment Not Available
0x01 0x0315 Invalid Segment Type or Segment Value in Path
0x01 0x0316 Path and Connection not equal in close
0x01 0x0317 Either Segment not present or Encoded Value in Network Segment is invalid.
0x01 0x0318 Link Address to Self Invalid
0x01 0x0319 Resources on Secondary Unavailable
0x01 0x031A Connection already established
0x01 0x031B Direct connection already established
0x01 0x031C Miscellaneous
0x01 0x031D Redundant connection mismatch
0x01 0x031D No more consumer resources available in the producing module
0x01 0x031E No connection resources exist for target path
0x01 0x0320- Vendor Specific