Fortinet FortiGate v3.0 MR7 - Manual (Page 29)

Authentication servers Directory Service servers
FortiOS v3.0 MR7 User Authentication User Guide
01-30007-0347-20080828
29
For more information about FSAE, see the FSAE Technical Note .
To configure the FortiGate unit for Directory Service authentication -
web-based manager
1 Go to User > Directory Service and select Create New.
2 Enter the following information, and select OK.
Figure 9: Directory Service server configuration
For information about Directory Service user groups, see “Configuring Directory
Service user groups” .
To configure the FortiGate unit for Directory Service authentication - CLI
config user fsae
edit
set ldap-server
set password password2
password3 password4 password5
set port port2 port3
port4 port5
set server server2 server3
server4 server5
end
Name Enter the name of the Directory Service server. This name appears in
the list of Directory Service servers when you create user groups.
FSAE Collector
IP/Name Enter the IP address or name of the Directory Service server where
this collector agent is installed. The maximum number of characters is
63.
Port Enter the TCP port used for Directory Service. This must be the same
as the FortiGate listening port specified in the FSAE collector agent
configuration.
Password Enter the password for the collector agent. This is required only if you
configured your FSAE collector agent to require authenticated access.
LDAP Server Select the check box and select an LDAP server to access the
Directory Service.