Replacement instructions, Kühl user interface service kit, For use with kühl – Friedrich KUHL R-410A User Manual

Page 80: And kühl, Attention, Mounting screws ribbon cable connection

Kühl User Interface Service Kit

Replacement Instructions

For Use with Kühl

(cool only models)

and Kühl +

(cool and heat models)

ATTENTION! -

Please read these instructions completely before attempting replacement.

Always unplug the power supply from the power supply receptacle.

Contents:

• User

Interface

(UI)

• Ribbon

Cable

• 2 – Mounting screws for UI

• Instruction

Sheet

Step 1.

Disconnect ribbon cable by pulling straight out

Step 2.

Remove 2 –mounting screws securing UI and disconnect ribbon cable

Step 3.

Remove UI and ribbon cable from handle assembly

Step 4.

Install new UI using the 2-screws, route new ribbon cable and reattach ribbon cable to UI
and Main control board

Step 5.

Verify control operation

Mounting screws

Ribbon cable connection