Furuno FAR-2107(-BB) - Manual (Page 83)

1. RADAR OPERATION
1-61
[BARGE INFORMATION]
1 BACK
2 BARGE MARK
OFF/ON
3 BARGE SIZE
LENGTH
0ft
WIDTH 0ft
4 ARRANGEMENT
4
9
9
9
4
1.34.5 Barge marker
You may mark the locations of barges on the display with icons. This feature is
available with an installation preset. Set up barge information as follows:
1. Left-click the MENU box to open the menu.
2. Select 2 [MARK] to show the MARK menu.
3. Select 7 [BARGE MARK].
BARGE INFORMATION menu
4. Select 2 [BARGE MARK] and push the left button. Select ON and push the
left button.
5. Select 3 BARGE SIZE and push the left button. Enter length (three digits)
and width (two digits) of barge.
6. Select 4 ARRANGEMENT and push the left button. This item lets you set a
single barge or a barge chain. Select one of the five arrangements and push
the scrollwheel. Select number of barges (max. 9) to display. As you roll the
scrollwheel the squares light or extinguish and the number of barges
selected appears at the right side.
7. Push the right button twice to close the menu.
X
Barge
Far left is 1st row
1.34.6 INS marker
You can get predicted position data by connecting this radar to an INS.
1. Open the menu and select 2 [MARK].
2. Spin the scrollwheel to select 7 [INS MARK] and 7 PREDICTOR.
3. Select ON.
4. Push the right button three times to close the menu.