Furuno FAR-2107(-BB) - Manual (Page 114)

1. RADAR OPERATION
1-92
• Radar functions are controlled independently, dependently or commonly
depending on selection as Master or Slave.
RADAR FUNCTIONS CONTROL MASTER DISPLAY OPTION SLAVE DISPLAY OPTION
AIS function
Brilliance
Echo stretch
Echo averaging
Echo trails
EBL
Lat/long data
Presentation mode
Speed data
Target alarm
TT, AIS on/off
TT, AIS track interval
Vector mode
Vector time
VRM
Wiper
Zoom
Range
(Sampling at Master)
A/C SEA
A/C RAIN
Auto Rain
Gain
IR
Picture setting
STBY/TX
Tuning
Reference point
TT LOST alarm
TT COLLISION alarm
TT alarms ACK
TT acquire
TT/AIS AZ
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Independent
Dependent Control
Dependent Control
Dependent Control
Dependent Control
Dependent Control
Dependent Control
Dependent Control
Dependent Control
Dependent Control
Common Control
Common Control
Common Control
Common Control
Common Control Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
(Echo Sampling at Master Range)
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Item Commonly Controlled
Item Commonly Controlled
Item Commonly Controlled
Item Commonly Controlled
Item Commonly Controlled Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Desired Value Can be set
Cannot control
Cannot control
Cannot control
Cannot control
Cannot control
Cannot control
Cannot control
Cannot control
Cannot control
Item Commonly Controlled
Item Commonly Controlled
Item Commonly Controlled
Item Commonly Controlled
Item Commonly Controlled
• If the message "CHECK INT-SW" appears, do one of the following as
applicable:
- If only your antenna is not displayed on the ANTENNA SELECT display,
LAN line in your processor may be faulty. In this case, use the standalone
mode.
- If the antenna that was in use does not appear on the ANTENNA SELECT
display, LAN line in other processor unit may be faulty. In this case, see page
1-91 for how to select a different antenna unit.
• When the Network fails, the Interswitch does not work, but standalone
operation is possible.
• With the dual radar display active, antenna and display can be selected from
the initial settings screen.