FUJITSU P300 - Manual (Page 45)

31
6 Push the board up to its slot (1).
Ensure that the end of a long board without angle bracket fits into the corresponding guide of the
casing.
7 Press the board into the slot so that it engages.
8 Fasten the board into place with the screw (2).
9 If necessary, connect the cables.
10 Close the casing (see "Closing the casing").
If you have installed or removed a PCI board, please check the relevant PCI slot settings
in the BIOS Setup. If necessary, change the settings. Further information is provided in the
PCI board documentation.
2
5 Make the required settings for the board.
CHAPTER 4 Washingtons (27-38) 16/10/2002, 4:13 PM 31