FUJITSU P300 - Manual (Page 37)

23
The screen stays blank
If your screen remains blank this may be due to the following:
Monitor is switched off
Switch your monitor on.
Power saving has been activated (screen is blank)
Press any key on the keyboard.
or
Deactivate the screen saver. Enter the appropriate password.
Brightness control is set too dark
Adjust the brightness control. For detailed information, please refer to the operating manual
supplied with your monitor.
Power cable not connected
Switch off the monitor and the PC.
Check that the power cable of the monitor is properly connected to the monitor and, depending
on the connector, to the system unit or to the grounded mains outlet.
Check that the power cable of the PC is plugged properly into the system unit and grounded mains
outlet.
Switch on the monitor and the system unit.
Monitor cable not connected
Switch off the monitor and the system unit.
Check that the monitor cable is properly connected to the system unit and monitor.
Switch on the monitor and the system unit.
CHAPTER 3 Washingtons (21-26) 16/10/2002, 4:13 PM 23