FUJITSU MPE3XXXAE - Manual (Page 120)

C141-E093-01EN 5 - 55
•
Self test execution status
Bits 0 to 3: Indicates the rest of self-test in 0 to 9 (corresponding 0 to 90%).
Bit 4 to 7: Indicates the self-test execution status at the following table.
Self-test
execution status
Meaning
0 Self-test has been completed normally or has not been executed.
1 Self-test has been stopped by the host computer.
2 Self-test has been suspended by hard or soft reset.
3 Self-test has been aborted by a fatal error.
4 Self-test has been completed abnormally by an unknown meaning.
5 Self-test has been completed abnormally by write test.
6 Self-test has been completed abnormally by serbo test.
7 Self-test has been completed abnormally by read test.
8 to 14 Reserved
15 Self-test is in progress.
•
Off-line data collection capability
Indicates the method of off-line data collection carried out by the drive. If the off-line data
collection capability is 0, it indicates that off-line data collection is not supported.
Bit Meaning
0 Indicates that Execute Off-Line Immediate is supported.
1 Vendor unique
2 Indicates that off-line data collection being executed is aborted when a
new command is received.
3 Indicates that supports off-line read scan function.
4 Indicates that supports self-test function.
•
Failure prediction capability flag
Bit 0: The attribute value data is saved to a media before the device enters power saving
mode.
Bit 1: The device automatically saves the attribute value data to a media after the
previously set operation.
Bits 2 to 15: Reserved bits