Connect the genie camera, Connectors – Faber Genie M1600 User Manual
Page 23
Genie Monochrome Series-GigE Vision Camera
Installing the Genie Camera • 21
Connect the Genie Camera
Connect a power supply to the Genie camera and an Ethernet cable from the Genie to the host computer. Once
communication with the host computer is started the automatic IP configuration sequence will assign an LLA IP
address as described in section
"
Genie IP Configuration Sequence
" on page 23
, or a DHCP IP address if a DHCP
server is present on your network. The factory defaults for Genie is Persistent IP disabled and DHCP enabled with
LLA always enabled as per the GigE Vision specification. For additional information see
" on page 77
. See the next section
" on page 21
for an overview of the Genie interfaces.
Connectors
The Genie has only two connectors:
• A single RJ45 Ethernet connector for control and video data transmitted to/from the host computer Gigabit
NIC. See
"
Ruggedized RJ45 Ethernet Cables
" on page 97
for secure cables.
• A single 12-pin Hirose male connector for camera power plus trigger, strobe and general I/O signals. The
suggested female cable mating connector is Hirose model HR10A-10P-12S.
The Genie has one multicolor LED to provide a simple visible indication of camera state (see figure below and
section
"
" on page 22
). Additionally the RJ45 has two LEDs for network status conditions.
The following figure of the Genie back end shows connector and LED locations. See
"
on page 89
for details on the Genie connectors and camera mounting dimensions.
Genie – Rear View