beautypg.com

Furuno GP-7000F User Manual

Page 23

background image

17

4. Position the second cable clamp halfway between the first clamp and the cable hole. Mark this

mounting hole.

5. If a hole has been drilled in the transom, open the appropriate slot in the transom cable cover.

Position the cover over the cable where it enters the hull. Mark the two mounting holes.

6. At each of the marked locations, use a 3 mm or 1/8" bit to drill a hole 10 mm (3/8") deep. The

prevent drilling too deeply, wrap masking tape around the bit 10 mm (3/8") from the point.

7. Apply marine sealant to the threads of the #6 x 1/2" self-tapping screw to prevent water from

seeping into the transom. If you have drilled a hole through the transom, apply marine sealant
to the space around the cable where it passes through the transom.

8. Position the two cable clamps and fasten them in place. If used, push the cable cover over the

cable and screw it in place.

9. Route the cable to the instrument being careful not to tear the cable jacket when passing it

though the bulkhead(s) and other parts of the boat. To reduce electrical interference, separate
the sensor cable from other electrical wiring and "noise" sources. Coil any excess cable and
secure it in place with zip-ties to prevent damage.