Fostex MR-8CD - Manual (Page 44)

44
MR-8HD/CD Owner’s Manual (Advanced playback and locate functions)
• By holding down the [F FWD] key during play
back, the recorder starts cueing forwards at 3 x
speed.
During forward cueing, " >> " is shown on the
display.
• By holding down the [REWIND] key during play
back, the recorder starts cueing backwards at 3
x speed.
During backward cueing, " << " is shown on the
display.
When the LOCATE A and LOCATE B points are set, you can playback between these points once.
This function is always available regardless of the play mode setting (see "
Play mode " on next
page). This function allows you to check the editing part (between LOCATE A and B points) for
copy/paste, erase, etc. See "
Part editing " described later.
By holding down the [ F FWD ] or [ REWIND ] key during playback, the recorder enters cueing mode
and you can monitor playback at 3 x speed. It may be useful for searching a specific position.
• While the recorder is stopped, press the [PLAY]
key while holding down the [STOP] key.
The MR-8HD/CD plays back audio data
between the LOCATE A and LOCATE B points
once, then stops.
: If you carry out the operation above when
the LOCATE A point is set ahead of the LOCATE B
point (i.e. LOCATE A > LOCATE B), the MR-8HD/
CD plays back audio data from the LOCATE A
point to the REC END points once, then stops.
: Note that this function is available only
when the LOCATE A and B points are set.
See page 49 for details about how to set the LO-
CATE A and B points.
LOCATE A point
Playback
LOCATE B point
During playback, you can monitor playback
audio of the desired track(s) by raising the ap-
propriate track fader(s), the [
MASTER ] fader
and the [ PHONES ] control.
While the recorder is playing back between the
LOCATE A and B points, the display shows the
icon as below.
LOCATE REC END
A-B PLAY
LOCATE ABS ZERO
PLAY STOP RECORD REWIND F FWD
LOCATE REC END
A-B PLAY
LOCATE ABS ZERO
PLAY STOP RECORD REWIND F FWD
[REWIND] key [F FWD] key
[STOP] key [PLAY] key
3 x cueing
Playback between LOCATE A and B points