Fostex MR-8CD - Manual (Page 133)

133
MR-8HD/CD Owner’s Manual (Troubleshooting)
I cannot execute auto punch in/out.
• Is " " shown on the screen?
If it is not, press the [AUTO PUNCH] key to make
the auto punch in/out function active.
• Are the punch-in and punch-out points set
correctly?
To check each point, press the [LOCATE A/IN] or
[LOCATE B/OUT] key. The recorder locates to the
punch-in or punch-out point, while the screen shows
the appropriate time data.
If the punch-out point is earlier than the punch-in
point, set these points appropriately so that the
punch-in point is earlier than the punch-out point.
During playback, the recorder suddenly executes locat-
ing.
• Is " " or " " shown on the
display?
If so, the play mode is set to the auto return or loop
mode.
Press the [PLAY MODE] key until "Off" is selected.
Cannot monitor the playback sound.
• Are the track fader(s) for the playback
track(s) and the [MASTER] fader brought up
to the appropriate positions?
Raise the fader(s) for the track(s) you want to
monitor, as well as the [MASTER] fader.
If you monitor via headphones, also raise the
[PHONES VOL] control.
I cannot record audio data of a song onto an external
digital recorder.
• Is the connection between the
[DIGITAL OUT] connector on the
MR-8HD/CD and the optical input
connector of the digital recorder made
correctly?
Check the connection, as well as the optical cable.
• Is the digital recorder set correctly for
recording the signal fed to the digital input?
See the manual of the digital recorder for details
about the setting.
I press the [PLAY] key while holding down the [STOP]
key, but I cannot execute loop playback.
• Are the LOCATE A and LOCATE B points
set correctly?
By default, both of these points are set to the
beginning of a song (i.e. "0m 00s 000ms" or "-2bar
1beat 00clk"). In this condition, you cannot execute
loop playback.
Also, if the LOCATE B point is earlier than the
LOCATE A point, you cannot execute loop playback.
Troubles for playback