Furuno GP-1850DF User Manual
Page 42
4-4
Handling of Coaxial Cable
•
Do not touch the connector with bare hands;
use gloves.
•
Use radio pincers to remove, and pull out
straightly.
•
Plug in connector straightly.
3. Fasten the GR-7000A (DGPS beacon receiver) to the heat sink with four 3X8
screws as shown in the figure below.
Screws (3 X 8), 4pcs.
DGPS Beacon receiver
GR-7000A
GN-7707
Figure 4-4 Installation of DGPS beacon receiver
4. Open the cover of GR-7000A to connect two coaxial cables shown below.
J2
From GN-7707
J3
J1
Piece of shrink tubing
Cable Assy.
S.FL2-2LP0.7-D-WHT (250) (Supplied with DGPS kit)
Mini pin coax. cable
Figure 4-5 Connecting the coaxial cables in GR-7000A
5. Close the cover of GR-7000A passing the two cables out through respective
notches in the cover.
6. Plug PH6P-W-L240 connector to J2 on the GR-7000A through the cover.
- MARINE RADAR 1953C (100 pages)
- GP-1650D (2 pages)
- GP-1650WD (96 pages)
- GP-1650W (96 pages)
- NAVNET 1943C-BB (92 pages)
- GD-3300 (137 pages)
- DUAL GPS GP-150-DUAL (130 pages)
- GP-1650WF (113 pages)
- CH-300 (124 pages)
- NX-300 (65 pages)
- NX-300 (2 pages)
- GP-1850WDF (115 pages)
- GP-3500 (192 pages)
- GP-1850WD (44 pages)
- GP-1850W (98 pages)
- GP-1850WD (98 pages)
- GP-1850W (4 pages)
- GP-1850W (98 pages)
- INTERFACE UNIT IF-2500 (12 pages)
- GP-31 (2 pages)
- GP-33 (98 pages)
- GP-7000 (28 pages)
- GP-7000 (2 pages)
- GP37 (2 pages)
- GP-90 (36 pages)
- CI-35 (69 pages)
- GP-1850F (110 pages)
- GP-30 (2 pages)
- FCV-30 (110 pages)
- BACK GP-80 (103 pages)
- LC-90 MARK-II (2 pages)
- GP-1650W (44 pages)
- DD-80 (119 pages)
- RP-250 (73 pages)
- GP-1650 (94 pages)
- GP-185F (4 pages)
- GP-1600F (97 pages)
- GP-1850D (94 pages)
- GP-7000F (132 pages)
- GP-7000F (52 pages)
- GP-36 (81 pages)
- GP-150-DUAL (123 pages)
- GP-80 (37 pages)
- 1650WDF (4 pages)